Domain Controller Force Replication

Here is a handy tip on how to force replication of windows 2008 domain controllers using repadmin.

Domain controller force replication. Repadmin is the ultimate replication diagnostic tool. There is a gui and a command line. Log on to one of your domain controllers.

From time to time its necessary to kick off ad replication to speed up a task you may be doing or just a good too to check the status of replication between dc s. If you re familiar with the good old windows cmd then the repadmin command is for you. Triggers the immediate replication of the specified directory partition to a destination domain controller from a source domain controller.

This command forces the kcc knowledge consistency checker on targeted domain controller s to immediately recalculate its inbound replication topology. If you re not familiar then this is a good time to learn about windows cmd. There is a gui and a command line.

Log in to one of your dcs and open the command prompt. The domain name and the domain partition don t need to be specified. Force replication of domain controllers through cli command.

It ensures synchronization between replication partners. Start windows powershell with administrative privileges. Force active directory replication between domain controllers you can use this procedure to force active directory replication to occur between two domain controllers on a one time basis when you want changes to be replicated from the server that received the changes to a server in another site sooner than the site link schedule allows.

In addition to checking the health of your domain controllers it can also be used to force replication and pin point errors. Force replication of all domain controllers on all sites. Further expand the server name and finally click on ntds settings.